Søg på hele sitet
Viser resultater for tags 'failed'.
Fandt 2 resultater
-
Hi! I'm new in this forum and from Sweden. I hope it's fine that I'll take this in English. comment in what ever language you prefer. I have had a IHC gen 1 since 2001 isch. It has worked really without any problems. Anyway, I decided to upgrade to latest version of controller before it is too late, hoping to get some more possibilities for integration to other system like HA etc. After I have reprogrammed every configuration I today was ready to upload the config to the new controller. I updated to latest FW and configured IP, time and DNS. But when trying to upload it stop on the 4'th line with a red cross and then a error message pops up telling that "the controller failed to parse the project". Then it was impossible to upload anything. Controller was in fault state. I then needed to load the factory default FW and then after redoing the initial configuration I tried with a very simple config, with just a few devices added, and that works fine. But then I again tried with a more complete config and again it fails the same way. Anyone have any tip why it fails and if there is some way to check the config before crashing the controller?
-
Nogen der måske kan hjælpe med mit problem om manglende forbindelse via min IHCRemote android APP. Jeg ønsker bare forbindelse via LAN, men den skriver hele tiden "Authentication Failed, Please verify settings" ved opstart og forsøg på forbindelse !?!? Når jeg taster de samme oplysninger i App'en på min iPad virker det fint
