Vladimir

Thank you both. Sure, I read the help file and I know that I can add and configure input/output modules in the software app even without connecting the controller. One thing is still unclear for me however. Let's say, I will add into the app three virtual switches I need to operate and will even pre-configure them and test configuration. Then I will connect a few of Input modules that have the several switches connected. How can I explain to the controller, which real switch should be mapped to a virtual one? In the 1st version of Visual app everything was organized under numbers of ports at controller/modules. The Visual ver. 2 app uses a paradigm of rooms, so I am quite confused how hardware and software components are mapped. There is the nice explanation how to add virtual devices in the help manual but nothing said about mapping.

Hello In a home I have bought recently, I have IHC controller version 1 based setup with wired input/output modules (no wireless). I plan to change IHC controller version 1 to version 2. As I understand, I should: Power off the controller, Disconnect all input/output wires, Connect them to the same sockets in controller 2, Power the new controller on and start setup process in IHC Visual app. My question - when I will power the new controller, will it automatically recognize all input/output modules in IHC visual app or I have to enter them manually? What else should I know to make the migration safe and efficient? Any help will be appreciated

Hello, PLampi! No, I still haven't found the software distributive. If you could share the content of the CD you have with me, that would be appreciated!

There is the answer from Schneider support: Not really helpful. Especially, because IHC was not very popular in Estonia. They know that software have been available! Still, if someone could share English distributive of IHC Visual 1.3 (or earlier) that would be very much appreciated.

No, Finnish version will not help, thanks for that! I have contacted the customer service, hope they will answer.

Yes, I have seen that topic. That is about Visual 3. I need Visual version 1.

Hello from Estonia. I bought a house with IHC version 1 run. I have an old computer with English IHC visual ver. 0,5 installed, but no installation media. I need to run it on another, more modern computer but cannot find any tracks of English software in Internet. Only Danish version is distributed around. If anyone has the installatsioon distributive of IHC Visual 1 English version, please send me link here or to my email vladimirtomberg@gmail.com.