controller tilted during firmware upload

[Timo R]

 

After long time I finally got USB connection to my controller. Read somewhere that up to date firmware would relief some of the java / usb connection problems.

However, the firmware upload crashed at the very end and now the controller doesn't reply to anything.  I get it usb connected to firmware loader, but when up load is about to start, pops message that internal failure.

And now I'm fully stuck.

Any advice?

[Lars Jacobsen]

Try with an old firmware.

Try with tho Old firmware loader from the download sektion here on the board.

It could alså be related to a lose circuit board inside the controller. Then you have to open it and just put it correct back in the slot.

 

[Infernoken]

Perhaps you can try to upload the 'factory reset' firmware:

 

 

And then update with the normal firmware again...?

 

[Timo R]

I tried with the same previous loader and older firmware without luck.

Dont have older loader, but that could work. Any hint where  to get? Everything seems to be on Danish pages and makes even more hard.

That factory reset tool sounds good! I try it later today. thanks already

 

[Timo R]

Can't get factory reset firmware uploaded with earlier used firmware loader. So, seems that different firmware doesn't help.

Haven't yet found other version of firmware loader.

 

[Lars Jacobsen]

 

[Timo R]

 

did work out. Still same failure.